Installation Guides

Mark each bracket on the side panel at the required measurements (Simply Wardrobes standard set-up is 450mm spacings between shelves, but you can determine the spacings between the shelves to suit your storage requirements).

Pre-drill the screw holes for the brackets to be attached to the panel.

Screw brackets on side panel with supplied screws.

Mark brackets on wall at required heights using a level, at the same spacings you have marked on the side panel.

Pre-drill holes for brackets going on wall and use plaster mates (gib board fixings) if no solid fixing. Attach brackets using supplied screws.

Attach L bracket to side panel and find solid fixing on wall (usually 800mm & 1600mm dwangs). This is to hold the panel in place.

Peel protective plastic off slats and start to clip into place, starting from the top.

Once all slats are in place, screw panel to the wall using the L bracket.